Building a connected nesting box network. Part 4

After we got the breadboard prototype running it was time to choose an enclosure and design a PCB to get everything together. For the board we choose not getting bigger as 10x10cm to keep costs down.

The enclosure

We searched for a waterproof enclosure which should house booth the solar charging regulator and the pcb. This project box turned out as a perfect fit.

project-box

The PCB

The PCB was designed to fit into the enclosure and hold most of the components from the breadboard. It was designed in KiCAD and ordered on smart-prototyping.

This was the first PCB designed by me, but it turned out very well.

Some pictures of the finished nodes in the boxes

Note that on the last 2 pictures the RPi box is on the lower right side. It’s basically the same PCB repurposed. Instead of a pluged in Arduino pro mini its connected through jumper wires to the GPIO.

This entry was posted in Nesting box. Bookmark the permalink.

One Response to Building a connected nesting box network. Part 4

  1. WilliamOr says:

    This is one awesome post.Really thank you! Fantastic. Girbach

Leave a Reply to WilliamOr Cancel reply

Your email address will not be published.

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>